|
DIN rail housing for Raspberry Pi...
PKW-LIGHT-STP-K6A 1.0 SW
SLIM® CAT6A Patchcords ROUND design - U/FTP shielded - 1,0m black
PKW-LIGHT-STP-K6A 1.5 GE
SLIM® CAT6A Patchcords ROUND design - U/FTP shielded - 1,5m yellow
PKW-LIGHT-STP-K6A 2.0 GE
SLIM® CAT6A Patchcords ROUND design - U/FTP shielded - 2,0m yellow
PKW-LIGHT-STP-K6A 2.0 GN
SLIM® CAT6A Patchcords ROUND design - U/FTP shielded - 2,0m green
PKW-LIGHT-STP-K6A 3.0 SW
SLIM® CAT6A Patchcords ROUND design - U/FTP shielded - 3,0m black
PKW-TOUGH-K6 2.0
SLIM® CAT6 Patchcords FLAT design with Nylon sheath - U/UTP unshielded - 2,0m grey
PKW-TOUGH-K6 2.0 BL
SLIM® CAT6 Patchcords FLAT design with Nylon sheath - U/UTP unshielded - 2,0m blue
PKW-TOUGH-K6 2.0 RT
SLIM® CAT6 Patchcords FLAT design with Nylon sheath - U/UTP unshielded - 2,0m red
PKW-LIGHT-STP-K6 0.15
SLIM® CAT6 Patchcords ROUND design - U/FTP shielded - 0,15m grey
PKW-LIGHT-STP-K6 0.15 GE
SLIM® CAT6 Patchcords ROUND design - U/FTP shielded - 0,15m yellow
PKW-LIGHT-STP-K6 0.15 GN
SLIM® CAT6 Patchcords ROUND design - U/FTP shielded - 0,15m green
PKW-LIGHT-STP-K6 0.15 OR
SLIM® CAT6 Patchcords ROUND design - U/FTP shielded - 0,15m orange
PKW-LIGHT-STP-K6 0.25 WS
SLIM® CAT6 Patchcords ROUND design - U/FTP shielded - 0,25m white
RPI RPDB
Raspberry Pi Debug Probe - Plug-and-play, USB to serial-debug & UART, 3-pin debug connector, Multiple debug platform supported
SHELLY PLUS 1
Shelly Plus 1 - relay switch for Wi-Fi. The relay switch can be used to control a wide range of products at any time and from anywhere. Shelly's relay switch turns your product into a smart one.
SHELLY UNI
Shelly UNI - controller module for Wi-Fi. The UNI controller module converts your device into a smart one. Two digital inputs and potential-free outputs.
WKK 21111940915
WKK 21111940915 - H-1 2:1 105C 12.7/6.4mm - transparent heat shrink tube in a box, length 5m
WKK 2132642015
WKK 2132642015 - H-2(3X) 3:1 125C 6.0/2.0mm - black heat shrink tube in a box, length 10m
WKK 2212101015
WKK 2212101015 - H-5(3X)-F 3:1 125C 12.0/4.0mm - black heat shrink tube with adhessive in a box, length 2.5m
ALCIH
Vention ALCIH - silver HDMI 2.1 Ultra High Speed 8K cable with textile braid, length 2.0m.
PEAK 1070
PeakTech® P 1070 - TÜV/GS approved pocket-size multimeter; modern design. Suitable for service technicians and electronics enthusiasts.
JIT JTTC66C
Joy-IT JTTC66C - USB 3.0 type-C multifunction voltage and ammeter with 0.96" IPS display.
WKK 27103102
WKK 27103102 - HSEC shrinkable cable end cap with glue ensures an excellent sealing of cable ends. This makes this perfectly suitable for low voltage applications.
WKK 11951971
WKK 11951971 - white cable tie fastener for 4,0mm cable ties with adhesive strip or screw-on with Ø3,5mm fixing hole, 100pcs per bag.
PEAK 3432
PeakTech® 3432 - Fuse finder with RCD tester and NCV detector.
SHELLY PLUS PMM3
Shelly PM Mini Gen3 - WiFi power meter.
LCD SBC01
Joy-It SBC-LCD01 - This IPS TFT display is controlled via SPI. This makes it suitable for use as an output device for microcontrollers (e.g. NodeMCU) and single-board computers (e.g. Raspberry Pi). By using a high-resolution IPS panel with a pixel density of over 260 PPI, content can be displayed in high-resolution on the compact display.
AM26LS32
QUAD EIA-422/3 LINE RECEIVER WITH THREE-STATE OUTPUTS
LM2917N14
Frequency to Voltage Converter with built-in zener
TPIC6A595NE
Power Logic 8-bit Shift Register (8x 50V 350mA outputs)