2. Arduino
  3. Arduino® Shield
  4. Arduino 4 Relays Shield (A000110)

Arduino® Shield

Manufacturers

Specials

Arduino 4 Relays Shield (A000110) View larger
Previous Next

Arduino 4 Relays Shield (A000110)

ARD A000110

1 Item

In stock

Manufacturer homepage

33,30 €

Original Arduino® A000110 - The Arduino 4 Relays Shield allows your Arduino to drive high power loads using relays.

Overview

The Arduino 4 Relays Shield is a solution for driving high power loads that cannot be controlled by Arduino's digital IOs, due to the current and voltage limits of the controller. The Shield features four relays, each relay provides 2 pole changeover contacts (NO and NC); in order to increase the current limit of each output the 2 changeover contacts have been put in parallel. Four LEDs indicate the on/off state of each relay.

The shield is compatible with all the Arduino boards, 5V and also 3.3V standards. Doesn't need external power.

Tech specs

Features

Thinker Kit interface2x TWI, 2x OUT, 2x IN
Interfaces with Arduino BoardDIO
Relays4 (60W)

General

Operating Voltage5 V
Current needs140 mA (with all releays on, about 35 mA each)
PCB Size53 x 68.5 mm
Weight0.044 Kg
Product CodeA000110

Input and Output

The relays are controlled by the following Arduino board pins: Relay 1 = Arduino pin 4 Relay 2 = Arduino pin 7 Relay 3 = Arduino pin 8 Relay 4 = Arduino pin 12 The shield features several TinkerKit input/output and communication interfaces. Connecting TinkerKit modules can simplify the creation of a project or a prototype. The on-board connectors are :

  • 2 TinkerKit Inputs: IN2 and IN3 (in white), these connectors are routed to the Arduino A2 and A3 analog input pins.
  • 2 TinkerKit Outputs: OUT5 and OUT6 (in orange), these connectors are routed to the Arduino PWM outputs on pins 5 and 6.
  • 2 TinkerKit TWI: these connectors (4-pin in white) are routed on the Arduino TWI interface. Both connect to the same TWI interface to allow you to create a chain of TWI devices.

Physical Characteristics

The maximum length and width of the 4 Relays Shield PCB are 2.7 and 2.1 inches respectively. Four screw holes allow the Shield to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.

Links

EAN7630049200654
click for more info
ManufacturerArduino
Manufacturer's modelA000110
 
Tuo ostoskori Excel-tiedostosta (.xls) jossa on tuotekoodit ja määrät